RUST CONVERTER

Can be used as a spray, a bath or through an injection process

Leaves a permanent chemically bonded surface coating to prevent rust from re-occurring.

Will not damage or contaminate metals or welds

Reduced work safe costs and worker safety issues disappear as no breathing apparatus, gloves, special clothing or special equipment other than standard safety goggles are needed.

There are no environmental charges or disposal fees after use.

It is non-corrosive and will not damage metal or plastic surfaces.

Shake well before use. Avoid freezing.

Remove all oil, grease, salt or other chemicals with a strong water soluble cleaner such as GETG’s HD Degreaser.

Remove blistered or loose paint, loose rust scale, and heavy rust buildup. *Do not remove all rust as product performs best when a thin layer of rust remains on the surface.

Pour estimated amount of Rust Converter to be used into clean container. Excess material cannot be returned to original container use.

Avoid getting on skin. Work GETG’s Rust Converter into surface with a nylon bristle brush. For large areas product can be rolled on or applied using an HVLP spray gun.

2nd coat must be applied 20 – 30 minutes after first coat. Only apply to areas small enough to add 2nd coat within this window. 2nd coat should be applied in a cross direction to the first.

Allow to dry for 24 hours. Rust and Corrosion Converter will dry to a matte black finish.

Clean up equipment immediately after application using water and GETG’s HD Degreaser. Once Rust Converter dries it will be difficult to impossible to remove.

Apply Rust Converter when the temp is between 10°C – 32°C (50°F – 90°F). Avoid direct sunlight and windy conditions. Apply to dry or damp (not wet) surfaces only.